Fresco applicable with tntEcco support how to proceed with the installation of a fresco applicable with tntEcco support To obtain the best results, we recommend treating the wall with a wall fixative If the temperature is high, it is advisable to wet the wall to prevent the glue from drying before laying.1) The first step is to outline the perimeter of the fresco. You can use a line and a pencil or even better than the paper ribbon.2) Spread the T.N.T. glue inside the traced perimeter using a roller or a brush.3) Now lay one side of the fresco and unroll paying particular attention to the traced perimeter.4) It is important to press on the surface to make the support adhere well to the wall and eliminate any air bubbles.5) You can grout the edge in a linear and square or jagged way. Apply paper ribbon along the edges to avoid smudging. In this case, the tape is applied in a corrugated manner to simulate jagged edges. 6) Now proceed with the grouting using a spatula. 7) Starting from the ribbon we proceed outwards for about fifteen centimetres. It is recommended to keep about one millimeter of plaster thickness in contact with the fresco and then cancel the thickness outward.8) After finishing the shaving you can proceed by applying the paint or your favorite decorative.
For information and phone orders: +39 02 83557910 | Monday-Friday | 9.00 AM - 1.00PM/2.00PM - 6.00PM GMYT +1 | Fax +39 02700520906 | Headquartes Via Pulci 13 20126 Milan Warehouse Viale Rodi 85 (driveway) 20126 Milan IT